CNC Shark Forum

Its hard to know what's going on because its fairly rare, and when it occurs one is concerned for the job, and doesn't necessarily take in all the pertinent facts about its occurrence...my current feelings are as follows:- As far as I can see there are (at least) two issues: 1. Losing the home posit...

When you load a new TAP file, the head always goes to zero when you start the run. Have you seen the topic on 'Issue with Pause' ? If you are running the 'i' version of the controller I would revert to the 'h' or earlier. Since I did this I have had no issues with shifts of coordinates while milling...

Ouch! Same issue. Speed change during cutting changed X axis setting, and then Pause made Z jump up about 20mm...luckily not down! This was during a job. I then did tests on a trial circle (converted to Bezier curves), and pause/speed change etc had no effect ...Have now reverted to the 'h' version ...

Ouch! Same issue. Speed change during cutting changed X axis setting, and then Pause made Z jump up about 20mm...luckily not down! This was during a job. I then did tests on a trial circle (converted to Bezier curves), and pause/speed change etc had not effect on settings, so its a rare event. Going...

Thanks Wolfie. i'm o/s at the moment so havent phoned aeg aust. in uk tjere is a Draper f/b router tha that looks like aeg. they told me the neck that fits base is 88mm diameter. it only costs 160 pounds. Can you tell me the diameter of the aeg neck please? also do you know if the Ridgid you mention...

Thanks Wolfie. i'm o/s at the moment so havent phoned aeg aust. in uk tjere is a Draper f/b router tha that looks like aeg. they told me the neck that fits base is 88mm diameter. it only costs 160 pounds. Can you tell me the diameter of the aeg neck please? also do you know if the Ridgid you mention...

Thanks...they say its a deleted line now! any other ideas, else i will have to source in uk. Does it fit shark without mods? thanks Rob.

By 'Bunnies' do you mean Bunnings? I have been trying to track down the collar size of the AEG 1400 - is it about 70.5mm? If not BUNNINGS where did you source it?
Thanks, Rob