CNC Shark Forum

HELP!!! Can you tell me why, in all 3 directions, X,Y and Z, my Shark(latest version) allows my router to slam into the ending stops. This includes driving my bit down into the wood on the Z axis. In fact, it continues to drive even after it hit the stops. This all happens while in the "Jog" mode, e...

I keep getting an error message while setting up Virtual Zero on my Shark HD that states: "Virtual Setup did not compete correctly. You must uncheck and run without virtual or try again to record your points. It is only correct, if the Recorded point near origin is set to Z=0.0" I move the bit over ...

ner Minnetonka Minnesota 55305

I've been pin nailing to a sacrificial board that works really well. Holds really well and removes easy. Otherwise Rockler has some new clamps that push into stops, which will allow you to have nothing on top. They can even push corner to corner.

Thanks for the info.

Is there any info out there on Shark maintenance and or "tuning up"?

I'm about to flip my really nice Mac into a PC by using a program called Bootcamp. Most later models of Macs have this software loaded already on them. It is my hope and what I'm told from the Apple experts, that by doing this I can run V-Crave and Aspire without any issues. Has anyone out there act...