CNC Shark Forum

Bob, Called next Wave and over a few days my HD 3.0 is 98% better. I did purchase a Z axes card and replaced the old the old one. Then check Z axes connection to lead-screw. Found the motor screw still tight and reassembled motor. The new board operation made Z movement very quite when operating. Ne...

Here is what I now know: I did go to your recommended trouble shooting Shark site. Changed Y and Z cables to control. Motors work fine as I was jogging the two axises. Put cables back to original position. Then I ran an op and with program in control had same Z problem. The tech support said it migh...

The servo motor operates but varies Z movement. Wrecked to good project pieces and figured I programmed settings differently. I currently think my servo motor is not pausing correctly. Could it something other then the motor ???

Will 2.1 ver, controller software run on Windows 10 ? ...or should I stick with Windows 7 ?

Thanks, Skip45

Does anyone have concerns about an upgrade to Microsoft 10? My concern is the new software for the Shark machine and ver. 8 Vetric software.

Skip45

John
Fond du Lac, Wisconsin 54937