Search found 4 matches
- Sun Nov 12, 2023 8:21 pm
- Forum: CNC Shark
- Topic: homing switches
- Replies: 2
- Views: 1043
homing switches
Shark hit a home run with their homing switches. I have an HD3 with an HD5 controller, so I had to retrofit my Shark to add the homing switches. That was easy to do with two magnets and some alien tape. (The HD5 controller is already set up to use homing switches.) As you start doing longer and bigg...
- Sun Nov 12, 2023 8:05 pm
- Forum: CNC Shark
- Topic: Shark Dust Boot
- Replies: 5
- Views: 2904
Re: Shark Dust Boot
The Shark dust boot just does not work. The bristles are too stiff. You cna deform the gantry on a deep cut, and throw your cutter off enough to affect the cut. Shark has not responded to concerns about this. The Kent dust boot works, and has a 4 inch vaccuum tube so you can get good results. I have...
- Mon Feb 20, 2017 10:09 pm
- Forum: CNC Shark
- Topic: using the VCarve engraver program
- Replies: 3
- Views: 2467
using the VCarve engraver program
Has enyone used the engraver program in VCarve? Where do you find the diamond engraving tools?
I would like to engrave a logo into stainless steel. I am not sure where to buy the diamond engraver they list.
Is the shark capable of engraving on steel?
I would like to engrave a logo into stainless steel. I am not sure where to buy the diamond engraver they list.
Is the shark capable of engraving on steel?
- Mon Feb 20, 2017 10:01 pm
- Forum: CNC Shark
- Topic: Newbie looking at an HD4
- Replies: 19
- Views: 10961
Re: Newbie looking at an HD4
SteveM got it right. Engineers do not know how to explain things to ordinary people. They put almost enough information into the book to get you interested, but only engineers can make it work. I really do not think the laser works. I have the laser setup guide, and the Laser engraving guide, but no...