LEADS

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
Mark Maslonkowski
Posts: 5
Joined: Sat Jul 16, 2011 9:32 am

LEADS

Post by Mark Maslonkowski »

I am trying to cut out some objects and the cutouts are the waste side. I am cutting these out using the cut inside line option and want to add leads but the leads are added to the outside not the waste side. If I change the cut location to on the line the leads move to the inside of the cutout where I would like them. I can move the start point to any number of locations on the cutouts and it still wont move the leads to the inside with a cut inside tool path. Any ideas would be great.


Mark Maslonkowski

User avatar
fison
Posts: 102
Joined: Thu Aug 26, 2010 10:24 pm
Location: Tacoma, Washington, USA
Contact:

Re: LEADS

Post by fison »

Mark,

Try adding a 'ramp' for inside cuts.
Paul Fison
Tacoma, Washington, USA
(253) 925-0855

Post Reply