Incomplete file load

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
airhed
Posts: 5
Joined: Wed Mar 16, 2016 10:53 pm

Incomplete file load

Post by airhed »

Trying to run tap file from flash drive and also from computer. Shark control panel shows complete file on screen but after running virtual setup and reloading tap file, it won't load complete file. Router starts up, makes a couple moves and goes back to Zero. Its obvious when this happens because green bar stops short of loading complete file. What am I doing wrong.

Post Reply