i can't cut arcs

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
Uncle Dutch
Posts: 2
Joined: Fri Dec 14, 2018 9:57 pm

i can't cut arcs

Post by Uncle Dutch »

I cannot cut arcs. Followed VCarve instructions, created a closed vector (a polyline with an arc for a profile cut), created a TAP file with the CNCShark-USB NewArcsc (mm) PP but my Shark II won't cut the arc. There are 2 little notches at the bottom where arc begins to be cut, but turns and forms a straight line. Got the VCarve file, the TAP and a photo of the finished "product".

https://drive.google.com/drive/folders/ ... sp=sharing

Could y'all please help?

Thank YOU,
Matt Holland
HollandCraft
p.352.470.9280

meisz
Posts: 22
Joined: Sat May 31, 2014 9:28 pm

Re: i can't cut arcs

Post by meisz »

Post a screen shot of your file so we an look at it

Uncle Dutch
Posts: 2
Joined: Fri Dec 14, 2018 9:57 pm

Re: i can't cut arcs

Post by Uncle Dutch »

Hmm...Not sure what you mean by screenshot. I attached all of the project files (TAP, CRV and JPG) in my original post. Will this help?

Post Reply