This is a video of how to create a raised panel with the BobART software. Because this is something I haven't done before I am looking for feedback.
http://screencast.com/t/qnt6iK9c4byO
Al
Raised Panel with BobART
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 75
- Joined: Sun May 08, 2011 4:13 am
- Location: Australia
Re: Raised Panel with BobART
Looks good but isn't this a panel thats sunken into the timber rather than a raised panel which usually comes up out of the timber? Maybe I'm miss understanding something.
I'm wanting to learn how to do it but I only have Vcarve Pro. Do you know if its possible or will I need to use BobArt?
Thanks for the video.
I'm wanting to learn how to do it but I only have Vcarve Pro. Do you know if its possible or will I need to use BobArt?
Thanks for the video.
“It’s not that I’m so smart,
it’s just that I stay with problems longer.“
Albert Einstein
it’s just that I stay with problems longer.“
Albert Einstein