Doesnt show my Post Processor on Cut3D

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
enriquewoodcarver
Posts: 60
Joined: Wed Apr 20, 2011 2:23 pm

Doesnt show my Post Processor on Cut3D

Post by enriquewoodcarver »

Im done with my project with all the difficulties on learnin how to use the program so Im about to save the toolpaths and it doesnt show my Post processor wich Im guessin it the same as the Vcarve Im using the one it was givin to me the "CNCShark-USB Arcs (inch) (*.tap)"
can someone tell me wat is the problem?

I have a pic where it doesnt show or do I used other processor and will work well too??
Attachments
post pro.png
ER

jeb2cav
Site Admin
Posts: 1524
Joined: Thu Sep 30, 2010 7:04 pm
Location: Kentucky
Contact:

Re: Doesnt show my Post Processor on Cut3D

Post by jeb2cav »

Hi ER,

Try thumbing through this post -http://www.cncsharktalk.com/viewtopic.php?f=10&t=109. It sounds like you may not have copied the Shark post processors to the Cut3D/PostP directory, and that's why they are not showing up.

Let us know if that solves it for you, or not. Lots of smart folks with good knowledge here.

Joe

Post Reply