Doesnt show my Post Processor on Cut3D
Posted: Fri Jul 29, 2011 3:08 pm
Im done with my project with all the difficulties on learnin how to use the program so Im about to save the toolpaths and it doesnt show my Post processor wich Im guessin it the same as the Vcarve Im using the one it was givin to me the "CNCShark-USB Arcs (inch) (*.tap)"
can someone tell me wat is the problem?
I have a pic where it doesnt show or do I used other processor and will work well too??
can someone tell me wat is the problem?
I have a pic where it doesnt show or do I used other processor and will work well too??