Im done with my project with all the difficulties on learnin how to use the program so Im about to save the toolpaths and it doesnt show my Post processor wich Im guessin it the same as the Vcarve Im using the one it was givin to me the "CNCShark-USB Arcs (inch) (*.tap)"
can someone tell me wat is the problem?
I have a pic where it doesnt show or do I used other processor and will work well too??
Doesnt show my Post Processor on Cut3D
Moderators: al wolford, sbk, Bob, Kayvon
-
enriquewoodcarver
- Posts: 60
- Joined: Wed Apr 20, 2011 2:23 pm
Re: Doesnt show my Post Processor on Cut3D
Hi ER,
Try thumbing through this post -http://www.cncsharktalk.com/viewtopic.php?f=10&t=109. It sounds like you may not have copied the Shark post processors to the Cut3D/PostP directory, and that's why they are not showing up.
Let us know if that solves it for you, or not. Lots of smart folks with good knowledge here.
Joe
Try thumbing through this post -http://www.cncsharktalk.com/viewtopic.php?f=10&t=109. It sounds like you may not have copied the Shark post processors to the Cut3D/PostP directory, and that's why they are not showing up.
Let us know if that solves it for you, or not. Lots of smart folks with good knowledge here.
Joe