Here is my wine serving tray. Grapevine graphics removed for copyrights. Note, the fillet cuts on the leg dado where the cross piece goes should be hand cut so they remain blind. Hope you like it.
Mike
Wine Serving Tray
Moderators: al wolford, sbk, Bob, Kayvon
Forum rules
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Wine Serving Tray
- Attachments
-
- Wine Serving Tray less grape vine.crv
- Tray front.
- (772 KiB) Downloaded 1041 times
-
- Wine Serving Tray Back.crv
- Tray back.
- (176 KiB) Downloaded 865 times
-
- Wine Serving Tray Legs.crv
- Legs and cross support.
- (770 KiB) Downloaded 867 times
Mako Shark
Re: Wine Serving Tray
real niceWineGuy wrote:Here is my wine serving tray. Grapevine graphics removed for copyrights. Note, the fillet cuts on the leg dado where the cross piece goes should be hand cut so they remain blind. Hope you like it.
Mike
Re: Wine Serving Tray
Thanks for the files
Tony
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 12.010, photo vcarve, cut3D.cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 12.010, photo vcarve, cut3D.cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
-
- Posts: 162
- Joined: Fri Jul 20, 2012 7:07 am
Re: Wine Serving Tray
Thank you for the files.
Eric the "WoodEraser"
Sun City Center, Florida
If today were perfect there would be no need for tomorrow.
Sun City Center, Florida
If today were perfect there would be no need for tomorrow.
Re: Wine Serving Tray
Thank you for sharing. Very nicely done!
Ed
Ed