Does anyone have a file to cut out FIDGET SPINNERS?
Moderators: al wolford, sbk, Bob, Kayvon
Forum rules
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
-
- Posts: 2
- Joined: Thu Jan 19, 2017 5:10 pm
Does anyone have a file to cut out FIDGET SPINNERS?
Looking for a file to cut out fidget spinners that are all the rage right now. My son really wants us to make one on the CNC. I am needing a file for a fidget spinner with 22mm bearings. Any help would be appreciated!
Re: Does anyone have a file to cut out FIDGET SPINNERS?
Like this?
Bob"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: Does anyone have a file to cut out FIDGET SPINNERS?
Here's one that's twice as good:
Bob"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: Does anyone have a file to cut out FIDGET SPINNERS?
This one's worth three dollars:
Bob"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: Does anyone have a file to cut out FIDGET SPINNERS?
Be sure to prepare the bearing by removing the side dust covers and all lubrication. Use them with no lubrication.
Bob
And remember, On all of these designs, your results may vary...
Bob
And remember, On all of these designs, your results may vary...
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: Does anyone have a file to cut out FIDGET SPINNERS?
And, How about this...The directions. Remember, your results may vary.
Is that enough information yet, Jonathan?
BobIs that enough information yet, Jonathan?
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
-
- Posts: 2
- Joined: Thu Jan 19, 2017 5:10 pm
Re: Does anyone have a file to cut out FIDGET SPINNERS?
Thank you Bob! Have not yet had a chance to check out your files but I will this evening. I really appreciate the response. I am just now learning this myself and made the attached file last night. It worked pretty good. Also, thanks for the tips on the bearings. I tried to epoxy them in place but it did not go so well..
Jonathan
Jonathan
- Attachments
-
- Fidget_Spinner.crv
- (384.5 KiB) Downloaded 513 times
Re: Does anyone have a file to cut out FIDGET SPINNERS?
Jonathan,
You're welcome.
And, thanks for posting your crv!
Have fun and try not to make the experience too complicated.
Bob
You're welcome.
And, thanks for posting your crv!
Have fun and try not to make the experience too complicated.
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)