Hello everyone
Used Vcarve 6. Wood is .25 red oak with shellac finish. Some assembly required.
First attempt with zipped files.
Chips
Fluer de Lis cup coasters with cart
Moderators: al wolford, sbk, Bob, Kayvon
Forum rules
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Fluer de Lis cup coasters with cart
- Attachments
-
- Fluer de lis coasters with cart.zip
- (993.91 KiB) Downloaded 1206 times
Re: Fluer de Lis cup coasters with cart
Chips,
Nice job.
Is there any chance you would export the file in the .eps format so earlier versions of VCarve could open it?
Thanks,
Bob
Nice job.
Is there any chance you would export the file in the .eps format so earlier versions of VCarve could open it?
Thanks,
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: Fluer de Lis cup coasters with cart
Bob
Sorry about that I wasn't thinking. Here are the new files in .eps format.
chips
Sorry about that I wasn't thinking. Here are the new files in .eps format.
chips
- Attachments
-
- Fluer de lis cup coasters and cart.zip
- (266.6 KiB) Downloaded 791 times
Re: Fluer de Lis cup coasters with cart
To all,
Something I just noticed and don't have answer for is the .eps format will distort the original drawing. So use caution when cutting.
My Disclaimer.
Chips
Something I just noticed and don't have answer for is the .eps format will distort the original drawing. So use caution when cutting.
My Disclaimer.
Chips
Re: Fluer de Lis cup coasters with cart
Thank you Chips.
I'm able to read the files!
All the measurements seem to check out real well.
I don't see any distortions at all. Since it's an .eps file, the tool paths are not there, but the drawing is. As long as there is a drawing and the picture, it's easy to generate new tool paths.
Nice work.
Bob
I'm able to read the files!
All the measurements seem to check out real well.
I don't see any distortions at all. Since it's an .eps file, the tool paths are not there, but the drawing is. As long as there is a drawing and the picture, it's easy to generate new tool paths.
Nice work.
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)