Touch plate
Moderators: al wolford, sbk, Bob, Kayvon
Touch plate
I finaly got around to installing touch plate on me Shark but cant get it to work. Is there some software I need to install I fallowed the instructions that came with it but cant get it to work.
Re: Touch plate
Does the controller have the choice to pick the Touchplate to set Z=0, or is it missing? If missing, you have to register the plate with NextWave, then they'll send you a code to enter to enable the touchplate choice to show up.
Re: Touch plate
There is no place to select it. I did register but did it today so wont get that till monday. Thanks
Re: Touch plate
wait for your number an it will work
Re: Touch plate
They should tell you in the instructions that it will not work tell you get the # from them. Everything else works for a trial time.
- TK@BullseyeGSD
- Posts: 7
- Joined: Sat Dec 15, 2012 2:36 pm
Re: Touch plate
Hey Kevin-
The instructions that I received with my touch plate did explain that I needed to register it and then I would receive an email with a key. I don't know if you received the same instructions but here is a pic of the section that talked about registering the touch plate. Hope this helps.
Troy
The instructions that I received with my touch plate did explain that I needed to register it and then I would receive an email with a key. I don't know if you received the same instructions but here is a pic of the section that talked about registering the touch plate. Hope this helps.
Troy
Re: Touch plate
got the same instructions but if it was like the controller and v-carve it should be able to use it while waiting for key.
Re: Touch plate
Unfortunately the Shark Control Panel ticks down 30 days - after that - any new accessory will require a Registration Key before you can 'see' it in the SCP.