CNC Shark Forum

I set up a file to cut using Vcarve.

Material is set to 'inches'
Thickness is set to .05

Profile cuts are set to 'cut through' material.
Start depth 0.0
Cut depth 0.059

Single pass cuts

Zdepth has been set with touch-plate.
***

I am getting a Zdepth cut of apx' 0.025" only. (Uniform across bed)

***
Saving out .tap using CNCShark-USB Arcs (inch)

I don't have the latest control panel installed (running F not H version, but I don't see this being the issue)
**

I must be missing something simple (?)

Please give me a nudge in the right direction fellow-troubleshooters.

Thank you

DougE

Doug,

Can you post the crv file? This way we will know more about it. Is your gantry set at normal height or is it set at the max height? If the gantry is set too high it will bottom out at the z stop and cut no further down.

Tony

Hi Tony

The gantry is set low. There are 2 bolt holes remaining at it's bottom to allow it to be raised 2 levels.

I changed the depth of the cut to accomidate a 'great' cut-through and not a skim through... wasted the sacrifical board completely but,.. that's why they call them that I suppose.

In any case, please take a look at the crv attached here if you would.

I rebooted VCarve and attempted to recreate the file (same results)
I changed the material settings to read in thousandths rather than .05 I tried to see if it was confused and put it in properly at .050. (no change)
I changed out blades to see if altering it's position in the spindle was causing it to come up short (no change)
The object is being cut in the center of the table (nothing near outer perimeter or max' cut range)
**shrug**

Thank you for your help and attention ! (Don't worry,.. I am not frantic about this project. I'll get it done by tomorrow night because I just found a bigger hammer!)

DougE