Page 1 of 1
e-mail
Posted: Mon Jul 14, 2014 9:17 pm
by gpeck
How do I send some one an email to show them what their project will look like, before I cut it out. Thanks for any info....
Re: e-mail
Posted: Tue Jul 15, 2014 3:34 am
by milo30
you rotate the picture to how you want it to be seen and then save it to your computer then attach ig to email. I am away from home and cant remember where the button is located but if you go into the 3d view where you would save the toolpath and do a little searching you will find it
Re: e-mail
Posted: Tue Jul 15, 2014 7:12 am
by Danwood
After you create the job and preview the tool paths in either Aspire or VCarvepro. You must save the Preview image.
This is a feature of the preview tool paths section.It will be in a Jpeg format.
Write the Email and attach the picture.
Re: e-mail
Posted: Mon Mar 02, 2015 9:06 pm
by gpeck
it opened in a bitmap file and I do not know how to change it to jpeg anyone help.??? thanks
Re: e-mail
Posted: Tue Mar 03, 2015 5:13 pm
by Ryan Richardson
After you've clicked the Save Preview Image button, in the dialog box that pops up, click the Save as Type box (under where you enter the file name) and you'll have options to save as other file types, including .jpg.
Hope that helps.