computer to use

Anything and everything CNC-Shark-related

Moderators: ddw, al wolford, sbk, Bob, Kayvon

Post Reply
Jimmy B
Posts: 11
Joined: Wed May 11, 2016 8:14 pm

computer to use

Post by Jimmy B »

I am new to this and I am expecting my extended table shark in a week or 2. I am going to purchase a new laptop to leave with the shark. Do I go with windows 10? it does not specify that in the description.

rsetina
Posts: 213
Joined: Sat May 04, 2013 5:05 pm

Re: computer to use

Post by rsetina »

You'll probably buy a computer with windows 8. I did and when it came out, I upgraded to 10. Either one will work fine with the software. I did the upgrade because it was free and read that it worked fine with Aspire 8.
Rick

Jimmy B
Posts: 11
Joined: Wed May 11, 2016 8:14 pm

Re: computer to use

Post by Jimmy B »

Thank you Rick, I am at best buy looking right now.

Post Reply