Has anyone here built a vacuum table?

Anything and everything CNC-Shark-related

Moderators: ddw, al wolford, sbk, Bob, Kayvon

Post Reply
cjablonski
Posts: 227
Joined: Mon Aug 13, 2012 7:16 pm

Has anyone here built a vacuum table?

Post by cjablonski »

I have acquired all the neccessary material and information but was wondering if anyone has any advice on how to proceed based on thier build experience. Hope to share mine here as I proceed.
"I'm not smart, I just remain on problems longer"
Albert Einstein

Making many BTU by experimentation. ...some days it gets too warm :)

Randy J
Posts: 7
Joined: Sun Oct 23, 2011 9:04 pm

Re: Has anyone here built a vacuum table?

Post by Randy J »

What type of Vacuum table are you planning to build? Universal (whole table vacuum through MDF) or Conventional (with gaskets per material/job part)?

cjablonski
Posts: 227
Joined: Mon Aug 13, 2012 7:16 pm

Re: Has anyone here built a vacuum table?

Post by cjablonski »

Kind of a hybrid of both
"I'm not smart, I just remain on problems longer"
Albert Einstein

Making many BTU by experimentation. ...some days it gets too warm :)

Post Reply