I recently bought the laser and all needed accessories to convert my controller. I tried running a test path and nothing happened except the Z axis went up and down . The controller just went back to the run screen after the router went up in down in the Z axis and the laser did not come on. I am running Vcarve Pro 10.0 and CNC Shark CP v1.6
Do I need to get another CP program, download something else, or what. Also I used CNCShark Laser (inch)(*.tap) as the post processor.
Any help would be greatly appreciated.
laser attachment
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: laser attachment
Here is the manual for the laser.
Tony
Tony
- Attachments
-
- laser manual.pdf
- (1.18 MiB) Downloaded 257 times
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 12.010, photo vcarve, cut3D.cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 12.010, photo vcarve, cut3D.cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
Re: laser attachment
I think I followed all the steps still cannot get the file to run.
Re: laser attachment
Look here for the download section for laser https://www.nextwaveautomation.com/downloads-links
Also contact nextwave
(419)491-4520
Tony
Also contact nextwave
(419)491-4520
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 12.010, photo vcarve, cut3D.cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 12.010, photo vcarve, cut3D.cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.