Router tip does not reach cnc bed or spoil board

Anything and everything CNC-Shark-related

Moderators: ddw, al wolford, sbk, Bob, Kayvon

jmarsz
Posts: 6
Joined: Sat Feb 10, 2024 10:08 am

Re: Router tip does not reach cnc bed or spoil board

Post by jmarsz »

I had unknowingly left tge plastic rings on the router. Which lifted the router out of the holder.
Remove the depth adjustment rings on the router. I didn't know they came off.

jmarsz
Posts: 6
Joined: Sat Feb 10, 2024 10:08 am

Re: Router tip does not reach cnc bed or spoil board

Post by jmarsz »

I actually had more prompt and friendly support from the Facebook group. Some of your replies were not helpful in the least. Your need to look down on new folks doesn't belong here.

User avatar
Bob
Posts: 1265
Joined: Sun Aug 08, 2010 3:35 pm

Re: Router tip does not reach cnc bed or spoil board

Post by Bob »

jmarsz wrote:
Thu Mar 28, 2024 12:19 pm
I had unknowingly left tge plastic rings on the router. Which lifted the router out of the holder.
Remove the depth adjustment rings on the router. I didn't know they came off.
jmarsz,
Thank you for sharing the solution to your problem. I'm sure it will be of help to others.
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)

Post Reply