For Sale CNC Shark Pro Routing System

[Henrymco]

Very gently used CNC Shark Pro Routing System item 39500, purchased in March 2011 from Rockler. Used for approximately 1 hour only. Due to family medical problems, we could no longer use it. Includes Bosch PR20EVSK Colt VS Palm Router, 4hold down clamps for T-Track, misc router bits, 3-d software. 5.0 VCarve Pro software Ship via UPS, continental U.S. Asking $3500.00,including shipping.

Contact; Henry@sunshine-faces.com

[lsvien]

where are you located? Local pickup?

[Henrymco]

I'm located in Davenport Fl, right next to Disney World

[dwmf56@gmail.com]

Is this item still available?

[Henrymco]

Is this item still available?

Yes it is

[Henrymco]

System is still available

[mcclerin]

I am interested in discussing the purchase of the Shark system directly w you - please send me email at manorhouse@skybest.com and I will respond immediately - would like to discuss purchase with you either by email or phone 336-877-1555.

Looking forward to hearing from you - Regards Rich

[mcclerin]

Henry

Please call me 336-877-1555 after 6PM Tuesday 9/4/12 to discuss purchase of Shark system

Regards
Rich

[mcclerin]

Henry

Please check and confirm registration of the Shark Pro and Vcarve software. It would be helpful to confirm the name in which the software is registered along with the registration number. Please advise if you can supply this information. Will speak w you tomorrow - thanks for the call today.

Regards

Rich