Someone out there must have experience carving text. Some of the text is .2-.25". I have been trying to us my 60 degree v-bit but it knocks out the center. of letters. Looked for a 30 degree bit, but have not had luck finding one.
What do you guys use and where do you get it?
james
Carving Text
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: Carving Text
For small letters like this you may want to look at engraving vice vcarving. A set of cutters I'm starting to find useful are - http://www.amanatool.com/ingroove/
Re: Carving Text
Whiteside Machine Company sells a "Carving Liner" bit tha is ~20 degrees.
I picked up one at Woodcraft for doing detail lettering.
http://www.whitesiderouterbits.com/
I picked up one at Woodcraft for doing detail lettering.
http://www.whitesiderouterbits.com/
Paul Fison
Tacoma, Washington, USA
(253) 925-0855
Tacoma, Washington, USA
(253) 925-0855