CNC Puranha hung up
Posted: Thu Feb 19, 2015 2:32 pm
This morning I was making test runs without the router in place. My new Piranha ran through the three tool path files correctly the first time. The file is complex and I am not very familiar with the machine.
On a second try it hung up. The mount stopped and the unit beeped but the display was completely dead. Nothing was visible on the display and it did not respond to touch.
I turned the unit off and then reset it. It cam on but it hung a second time at about the same location.
On the third try it ran steady for more than 30 minutes.
I am concerned that this is a major software error in that the display was dark. It is one thing to have a problem; it is another to have the screen go dead.
Thanks,
Tom Riley
On a second try it hung up. The mount stopped and the unit beeped but the display was completely dead. Nothing was visible on the display and it did not respond to touch.
I turned the unit off and then reset it. It cam on but it hung a second time at about the same location.
On the third try it ran steady for more than 30 minutes.
I am concerned that this is a major software error in that the display was dark. It is one thing to have a problem; it is another to have the screen go dead.
Thanks,
Tom Riley