Router bit drags in Z slightly
Posted: Sun Mar 14, 2021 5:05 pm
I am experiencing a new problem after several years of Shark HD4 ownership. I set the coordinates X,Y,Z as I have always done. For the past 2 projects the tool will drag (in Z) a bit making a mark in the wood. It is only a couple of thou's deep, but it pisses me off. I can use the Z setting block, or a piece of paper, getting the same results. I can sand it clear, but it should not do this. I do not know how to code. I am including the file that this is happening on.
Thanks for looking at my problem.
Thanks for looking at my problem.