New to CNC--Program Question
Posted: Wed Sep 28, 2022 8:42 pm
Hi everyone,
I was inspired by a friend of mine to give this hobby a shot. I recently ordered the smaller SD100 machine. I have been watching tutorials everyday on VCARVE and it is similar to programs that I have used in the past.
I just received my machine today and the manuals focus heavily on the program Ready2Control. My biggest issue with using this program is I do not have a laptop that I can set up next to the CNC machine. I only have a desktop which is on the other side of my house from where I will be using the machine. My plan prior to ordering my CNC machine, was to use VCARVE on my desktop, save the files to a thumbdrive and upload the thumbdrive files to the screen pendant and run it from there.
Is this possible or do I have to use Ready2Control?
Thank you in advance for my beginner question.
Cheers!
I was inspired by a friend of mine to give this hobby a shot. I recently ordered the smaller SD100 machine. I have been watching tutorials everyday on VCARVE and it is similar to programs that I have used in the past.
I just received my machine today and the manuals focus heavily on the program Ready2Control. My biggest issue with using this program is I do not have a laptop that I can set up next to the CNC machine. I only have a desktop which is on the other side of my house from where I will be using the machine. My plan prior to ordering my CNC machine, was to use VCARVE on my desktop, save the files to a thumbdrive and upload the thumbdrive files to the screen pendant and run it from there.
Is this possible or do I have to use Ready2Control?
Thank you in advance for my beginner question.
Cheers!