I posted this on the Vectric forum as well, but did not know if this might be specific issue to the Shark, so I posted here as well.
I am working on some lettering toolpaths and the lettering is coming out a little funky.
You can see it very pronounced in my letter E. This is happening with letters that are still editable text and letters converted to lines. The preview in VCarve does not show this.
I am sure there is just a checkbox that needs to be selected to fix this. Anybody know how to fix this one?
Thanks,
-Eric
Lettering Toolpaths
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Lettering Toolpaths
Thanks,
-Eric
Facebook.com/inspireddesignstx
-Eric
Facebook.com/inspireddesignstx
Re: Lettering Toolpaths
Eric,
Read this post. http://www.cncsharktalk.com/viewtopic.php?f=8&t=977 Look for Paul's reply. It should help get rid of the curvies.
Buc
Read this post. http://www.cncsharktalk.com/viewtopic.php?f=8&t=977 Look for Paul's reply. It should help get rid of the curvies.
Buc
I have not failed. I've just found 10,000 ways that won't work.
Thomas A. Edison
The Only Easy Day Was Yesterday
Thomas A. Edison
The Only Easy Day Was Yesterday
Re: Lettering Toolpaths
Thanks Buc!
That was it. Took me a while to find the folder Vectric puts post processors in now. Turns out the one I had was missing a lot of updates from Next Wave. I downloaded the most recent and made the change.
Thanks again,
-Eric
That was it. Took me a while to find the folder Vectric puts post processors in now. Turns out the one I had was missing a lot of updates from Next Wave. I downloaded the most recent and made the change.
Thanks again,
-Eric
Thanks,
-Eric
Facebook.com/inspireddesignstx
-Eric
Facebook.com/inspireddesignstx