Head/tailstock Alignment
Posted: Tue Jul 25, 2017 8:34 am
Greetings All,
I've just received my 4th axis kit and noticed that the center of the tailstock is 3/16" higher than the center of the head unit. I do a lot of turning and if my lathe tailstock was that far off, my pieces would be ruined. I have sent an email to NextWave but have not had any replies. Any suggestions?
Thanks,
Bob Pastor
I've just received my 4th axis kit and noticed that the center of the tailstock is 3/16" higher than the center of the head unit. I do a lot of turning and if my lathe tailstock was that far off, my pieces would be ruined. I have sent an email to NextWave but have not had any replies. Any suggestions?
Thanks,
Bob Pastor