Buc has been hinting that I should get going with some of the recent posts about a 3D method by Vectric and use those techniques in a project. (Well, he may not have been really hinting, but I sure wanted to try the technique.)
I used a .125" radius round over bit to make this carving using a profile tool path.
The original engraving is on the right. The fake 3D is on the left:
Bob
fake 3D stick man
Moderators: al wolford, sbk, Bob, Kayvon
fake 3D stick man
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: fake 3D stick man
Bob,
That's really cool. Looks great. Thanks for posting the picture. Thanks for allowing me to send you 12 emails in the last 2 days.
Buc
That's really cool. Looks great. Thanks for posting the picture. Thanks for allowing me to send you 12 emails in the last 2 days.
Buc
I have not failed. I've just found 10,000 ways that won't work.
Thomas A. Edison
The Only Easy Day Was Yesterday
Thomas A. Edison
The Only Easy Day Was Yesterday