fake 3D stick man
Posted: Tue Apr 24, 2012 8:03 pm
Buc has been hinting that I should get going with some of the recent posts about a 3D method by Vectric and use those techniques in a project. (Well, he may not have been really hinting, but I sure wanted to try the technique.)
I used a .125" radius round over bit to make this carving using a profile tool path.
The original engraving is on the right. The fake 3D is on the left:
Bob
I used a .125" radius round over bit to make this carving using a profile tool path.
The original engraving is on the right. The fake 3D is on the left:
- Old man on a walking stick handle.