Page 1 of 1
raised letters with background texture
Posted: Wed Aug 04, 2010 1:46 pm
by mpientka
An early project to get familiar with my Shark Pro
Re: raised letters with background texture
Posted: Wed Aug 04, 2010 7:26 pm
by glockhar
How did you determine which letters were raised and which letters were carved? I have a logo that initially carved around the letters and much of the pattern. Now it carves the letters and the pattern into the wood. It's like the negative of the original carving. Any ideas? Thanks
Gary
Re: raised letters with background texture
Posted: Thu Jan 11, 2018 9:19 pm
by dvaskie127
Check to see what vectors are selected. If there is a border selected it will carve around the letters if no border it will carve the letters
Re: raised letters with background texture
Posted: Fri Jan 12, 2018 11:25 am
by Kayvon
Hopefully that's helpful for future readers, but these two haven't logged in since 2010. It's a very old thread.
Re: raised letters with background texture
Posted: Fri Jan 12, 2018 3:47 pm
by Rando
Kayvon wrote:Hopefully that's helpful for future readers, but these two haven't logged in since 2010. It's a very old thread.
I was right on it, but he beat me to it
.