Used a .125 tapered ball nose to carve this going down .31 deep in .375 cast acrylic.
Tony
3D rose in acrylic
Moderators: al wolford, sbk, Bob, Kayvon
3D rose in acrylic
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
-
- Posts: 488
- Joined: Fri Apr 08, 2011 2:14 pm
Re: 3D rose in acrylic
Very nice Tony.Just in time for spring . Basecircle
Re: 3D rose in acrylic
Where did you get the 3d rose from?
THanks
THanks
Re: 3D rose in acrylic
The stem rose is from vectorart3d.com it came with the aspire disc
Tony
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
Re: 3D rose in acrylic
Thanks Tony. I guess I better get out my Aspire disk.
Steve
Steve
Re: 3D rose in acrylic
Taking a closer look, sure does look better smooth side to the front.