CNC Shark Forum

Hello,

would it be possible to engrave the barrel of a baseball wood bat?

I was going to make a jig to hold a bat then do a scan to pull into the design . . . That way I could do multiples . . . A local guy got approval from a team to have their signatures imprinted on the bats for souvenir resales.

Not easy with VCarve. Aspire and a jig to hold the bat somewhat like my indexing jig should make it possible.

Here is a link that might be helpful

http://www.cncsharktalk.com/viewtopic.p ... seball+bat

Not sure if it helps you on what you want to do but is a starting point for research. Not sure how flat the area is that you are wanting to engrave.

http://paulrowntree.weebly.com/warpdriver.html
might also be something of interest to your question.

And another link:
http://www.cncsharktalk.com/viewtopic.php?f=12&t=2436


Bob

4DThinker

Like the fence to minimize the chips/dust all over ...

McBuster wrote:Like the fence to minimize the chips/dust all over ...

Thanks. Not completely my own original idea, but once I swapped out my MDF top for t-track those side tracks kept yelling out at me for a use. The 1/4" plywood and spacers still allow the router mount to access all the possible cutting area.