Re: New user... having trouble getting a real clean cut on f
Posted: Tue Dec 13, 2011 7:24 am
Hi Lauren,
One thing I'd check is how much of the bit you have chucked into the router. I was working with a fellow the other day and in the end, the majority of his 'problem' was the result of not ensuring a reasonable amount of the shank was in the collet. As soon as he corrected this, the majority of his problems went away.
Are you using a Colt router? I have seen articles and posts where the TIR (roundout) of the spindle itself can vary quite a bit, and you may have a lemon in this regard. I have myself ended up with one of those (I've purchased 3 since starting). In that case, I had purchased the extended warranty from the big box store and took it back for exchange. I also invested in the precise bits collets for my use, and these do help this as well.
Assuming the cutter is in good shape (obliged to say it).
Your settings seem fine - but you don't mention an ipm feed rate or plunge rate. You can definitely try lowering both to see if that gets you what you want. I've found that a slower plunge rate can improve things for me, particularly in hard woods. Certainly there is a knee in the curve for the ipm as well, but generally with lettering the gantry never gets close to the ipm you've set - too much movement.
"What does that do" - is best explained in the VCarve manual - in VCarve, Help, Help Contents - this will open the manual in pdf form. Do a search for 'final pass stepover'.
Lastly, the font you are using could be contributing to this. If there are a lot of unnecessary vertices in the font, the Shark my be trying to get as close as possible to them and this movement is slight, but enough to contribute to this. You can get a sense of this by using the 'Convert Text to Curves' tool, and then selecting a problem letter and going into the node edit mode to see. There are some settings you can change in the tap file, but I'll hold off on that for now until you think about the above and let us know if any of it helps.
One thing I'd check is how much of the bit you have chucked into the router. I was working with a fellow the other day and in the end, the majority of his 'problem' was the result of not ensuring a reasonable amount of the shank was in the collet. As soon as he corrected this, the majority of his problems went away.
Are you using a Colt router? I have seen articles and posts where the TIR (roundout) of the spindle itself can vary quite a bit, and you may have a lemon in this regard. I have myself ended up with one of those (I've purchased 3 since starting). In that case, I had purchased the extended warranty from the big box store and took it back for exchange. I also invested in the precise bits collets for my use, and these do help this as well.
Assuming the cutter is in good shape (obliged to say it).
Your settings seem fine - but you don't mention an ipm feed rate or plunge rate. You can definitely try lowering both to see if that gets you what you want. I've found that a slower plunge rate can improve things for me, particularly in hard woods. Certainly there is a knee in the curve for the ipm as well, but generally with lettering the gantry never gets close to the ipm you've set - too much movement.
"What does that do" - is best explained in the VCarve manual - in VCarve, Help, Help Contents - this will open the manual in pdf form. Do a search for 'final pass stepover'.
Lastly, the font you are using could be contributing to this. If there are a lot of unnecessary vertices in the font, the Shark my be trying to get as close as possible to them and this movement is slight, but enough to contribute to this. You can get a sense of this by using the 'Convert Text to Curves' tool, and then selecting a problem letter and going into the node edit mode to see. There are some settings you can change in the tap file, but I'll hold off on that for now until you think about the above and let us know if any of it helps.