Work holding
Moderators: al wolford, sbk, Bob, Kayvon
Work holding
I am interested in knowing how others hold their work while cutting and engraving. I have been having a lot of difficulty getting consistent results with depth of cut. I know from reading other posts and investigating my machine it has a little to do with my bed being on a slightly different plane than the router and a little bit of "sag" due to the unsupported rail, but I feel a large amount is due to uneven clamping pressure. Has anyone else had this problem and if so have you figured a fix?
Re: Work holding
If you have the aluminum T-track an issue will arise when the clamp reaches from one track to the next piece as the clamp pressure will cause them to deflect away from each other. One solution if you don't use a scarf board is to make sure the clamp is T nutted to the same track as the board where the clamp contact will be placed. This will eliminate the adjoining track deflection.
If you use a scarf board that is thick enough, you can add threaded inserts to anchor your clamps. Take a look at this post to see how this might work for you. http://www.cncsharktalk.com/viewtopic.p ... carf+board
If you use a scarf board that is thick enough, you can add threaded inserts to anchor your clamps. Take a look at this post to see how this might work for you. http://www.cncsharktalk.com/viewtopic.p ... carf+board
-
- Posts: 1
- Joined: Fri Aug 29, 2014 12:15 pm
Re: Work holding
I have installed a 3/4" thick MDF over the entire work area and use drywall screws to mount registrer boards around the project blank and wedges to secure the blank in place. The 3/4" waste board also provides some needed stiffness to my extended length aluminum t-track table.
Re: Work holding
Thanks for the replies. I have been using a 3/4" MDF board, but it has never seemed to work very well. I guess I just need to go back to square one and take a little more time. I really like the dowel pin/bench dog inserts in the HDPE top, so I might try something like that.
I will let you know what I come up with.
I will let you know what I come up with.
Re: Work holding
Be sure that you surface the MDF before you use it to get it as level as you can. I use MDF and like screws when they are feasible. Sometimes it helps to drill the holes before using screws so it gets a good tight fit.
Re: Work holding
Hi,
I resolved that problem by creating some holding jigs.
Cut a pocket into the jig. that levels the jig regardless if the machine bed is out of whack.
then use a clamp ring.
any other minor adjustments can then be quickly made by simply adding a bit of masking tape under the jig on the low corner.
Also allows you to easily run multiple pieces without having to zero every time.
Hope that helps.
Dave
I resolved that problem by creating some holding jigs.
Cut a pocket into the jig. that levels the jig regardless if the machine bed is out of whack.
then use a clamp ring.
any other minor adjustments can then be quickly made by simply adding a bit of masking tape under the jig on the low corner.
Also allows you to easily run multiple pieces without having to zero every time.
Hope that helps.
Dave