What is the maximum HP router that could be mounted?

[ALFAHA]

Can you tell me if a Porter Cable 3-1/4 HP router could be installed on the Shark Pro Plus, or is it too heavy/strong to balance the stepper motors on the Shark? If it is, what is the maximum size router that could be installed on it? I am researching the possibility of using the Shark to V-carve granite with diamond tipped V-bits or ball end bits. I have successfully used the bits in a laminate trimmer sized router but am concerned about the feed rate control and load on the router over the course of producing 100+ pieces. If I can be convinced it can work I am ready to purchase. I have seen other machines with the 269 oz. stepper motors that accept the larger routers.
Thanks for the response!

[jeb2cav]

I'd send that question directly to Tim Owens at Next Wave Automation - towens@nextwaveautomation.com. There may be some on this forum who have used other routers and will respond here as well.

I think we'd all be interested in his response.

[ALFAHA]

Thanks for the contact information. I'll let you know what he says.

[ALFAHA]

Here was Tim's reply:

That is too large for the current carriage.
You can install the porta cable 1.25 hp one.

Thanks

Tim