Pro Plus construction
Moderators: al wolford, sbk, Bob, Kayvon
Pro Plus construction
Can anyone please tell me what is plastic and what is aluminium on this machine. At our local Detroit Rockler store nobody knows much about these machines except apparantly Dick who was not there. The table is aluminum but what about the base. Is the router carriage all plastic and what about the peices on the side that travel the Y axis. Does anyone know if you can get the machine without the v-carve and cut 3d software as I already have the software. Thanks in advance. Pete in Canada
Re: Pro Plus construction
Hi Pete
Its basically bolted together HDPE plastic sheet but quite rigid and nicely machined. The aluminium bits on the gantry are just stiffeners. The slides are all hardened precision ground round bar on Thomson linear bearings. The bed is standard Rockler tee section - wonderful if you have an accident! Some forum members have beefed up the anchoring method using aluminium angle. About the cheapest metal unit I have come across would be Probotix. That might solve your software problem?
Take care
Bob
Its basically bolted together HDPE plastic sheet but quite rigid and nicely machined. The aluminium bits on the gantry are just stiffeners. The slides are all hardened precision ground round bar on Thomson linear bearings. The bed is standard Rockler tee section - wonderful if you have an accident! Some forum members have beefed up the anchoring method using aluminium angle. About the cheapest metal unit I have come across would be Probotix. That might solve your software problem?
Take care
Bob
Re: Pro Plus construction
If you want to get a machine that is a modified package then what rockler has, you need to contact Next wave and we can quote it for you.
Thanks
Tim OWens
419 318-4822
Thanks
Tim OWens
419 318-4822
Re: Pro Plus construction
Thanks Tim. I will give them a call. Pete