I just tried a test probe of a star medallion in a 2" x 2" square.
This was my first on the Shark Pro Plus.
Set step on x & y at .01 and 10 in/min.
about half way thru z went up to Z0 for 1.75 passes.
I tapped it and it resumed without any problems.
My question is:
Without rescanning the whole project can I start scan near where problem started and marry the two scans?
Touch Probe Mapping
Moderators: al wolford, sbk, Bob, Kayvon
-
WoodEraser
- Posts: 162
- Joined: Fri Jul 20, 2012 7:07 am
Touch Probe Mapping
Eric the "WoodEraser"
Sun City Center, Florida
If today were perfect there would be no need for tomorrow.
Sun City Center, Florida
If today were perfect there would be no need for tomorrow.
Re: Touch Probe Mapping
If You want a good Image you must start over.
Bob
Bob