X axis adjustment

[sokker13]

My table is out of level on the X-axis by approximately 1/8th of an inch. I don't see anything in the very limited amout of manuals that show how to adjust or compensate to get the table level. Any suggestions would be greatly appreciated.

[RhB_HJ]

Loosen the gantry mounting screws to have them just snug, press the side frames of the gantry down. Re-check. You may have to equalize by bringing one side up and the other side down. When that's more or less level to the table check that the Z-axis is perpendicular to the table in both planes.

Minor discrepancies are usually taken up by using a sacrifice clamping board (MDF), which you surface with the router.

[rapiddawg]

Han's last comment is the best, level the table by making a complete surface cut.