Chinese Checkers Anyone?
Moderators: al wolford, sbk, Bob, Kayvon
Forum rules
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
- Consultingwoodworker
- Posts: 333
- Joined: Fri Jul 02, 2010 7:37 am
- Location: Nashville area
- Contact:
Chinese Checkers Anyone?
I wrote the programs and Woodworker's Journal's Rob Johnstone did the video. You can download the files for free!
http://www.woodworkersjournal.com/resou ... index.html
Enjoy!
Ralph
Re: Chinese Checkers Anyone?
Thanks again, Ralph!
I had it downloaded and have been looking through my scrap pile for something to cut one out from within 5 minutes of getting their email. Already ordered some marbles. Thinking about gluing up some beech to make one from. I've got a sister nearby that has at least 5 grandkids so far, and she is always looking for something like this to distract them when they are over. She'll have to keep it away from the toddlers though. Those marbles look too much like candy. I may have swallowed a few when I was a kid come to think of it.
I had it downloaded and have been looking through my scrap pile for something to cut one out from within 5 minutes of getting their email. Already ordered some marbles. Thinking about gluing up some beech to make one from. I've got a sister nearby that has at least 5 grandkids so far, and she is always looking for something like this to distract them when they are over. She'll have to keep it away from the toddlers though. Those marbles look too much like candy. I may have swallowed a few when I was a kid come to think of it.
Re: Chinese Checkers Anyone?
Thank you for the files Ralph.
Bob
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: Chinese Checkers Anyone?
Thanks Ralph. Your always a helping hand around here. Thanks a lot.
Tony
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
-
- Posts: 488
- Joined: Fri Apr 08, 2011 2:14 pm
Re: Chinese Checkers Anyone?
Thanks Ralph I will give it a shot Basecircle