Hi!
I am working with 3D stuff and have had the strangest issue.
Attached is a photo of a recent project, if you look at the center, there is a triangle on the face of the ship and a line that runs on each side of the work. This does not appear when i preview the file. I am using a 1/8" ball nose set to 50%.
I am not as familiar with Aspire as I would like, but am having fun learning. Any ideas?
Problem with 3D milling
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 48
- Joined: Sun Oct 12, 2014 9:04 pm
-
- Posts: 48
- Joined: Thu Jan 23, 2014 5:18 pm
Re: Problem with 3D milling
Is it possible that your safe Z height is set too low? Looks like the line happens as the bit is moving to a different area of the carving. Others will have better ideas.
Re: Problem with 3D milling
1/8" ball nose I have a stepover at 10% all my ballnose bits are set at between 8- 10 %, but it will carve a longer time. Can u post the aspire file if possible? You might be hitting the upper limit of your z which will lose steps and that is what u r seeing.
Tony
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
-
- Posts: 48
- Joined: Sun Oct 12, 2014 9:04 pm
Re: Problem with 3D milling
Attached are two screenshots from my settings.
Thanks again for the help!
Tony
Thanks again for the help!
Tony
Re: Problem with 3D milling
Your z setting is too high that is why your losing steps, set it at 1
Tony
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
-
- Posts: 48
- Joined: Sun Oct 12, 2014 9:04 pm
Re: Problem with 3D milling
I changed the Z setting and area machine strategy to raster and wallah!
Still a faint trace of that strange "line" but looks great!
Thanks for the help tony!
Still a faint trace of that strange "line" but looks great!
Thanks for the help tony!