Random circle twice

Anything and everything CNC-Shark-related

Moderators: ddw, al wolford, sbk, Bob, Kayvon

Post Reply
Char
Posts: 13
Joined: Wed Jun 20, 2018 8:33 pm
Location: Eagle River WI

Random circle twice

Post by Char »

The tap file is attached and a photo of what happened.
Trying to think of where something went wrong. This happened the first time which is in the photos so I pulled the piece, planed it back down to a zero and went through the entire project to start over on a thinner piece of material. I was cutting this plaque out for a donation to our local VFW event but after two attempts and this same glitch in the same spot I dont know what happened.
I can tell you before the second run I had replaced and moved the emblems around ,recalculated each toolpath individually and ran the preview all toolpaths multiple times it all looked spot on.

The issue occurred just before line 7675.

Thank for any help
Attachments
Clean out.tap
(1 MiB) Downloaded 241 times
First time
First time
second time
second time
Be the kind of woman a man fears, fix things, build things and do it right the first time!

tonydude
Posts: 1581
Joined: Tue Aug 17, 2010 9:23 am
Location: Buffalo,NY

Re: Random circle twice

Post by tonydude »

can you post the crv file instead? Can't tell from the tap file


Tony
Buffalo,NY

"What will matter is not what you bought but what you built; not what you got, but what you gave”

Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.

sharkcutup
Posts: 408
Joined: Tue Mar 08, 2016 5:23 pm

Re: Random circle twice

Post by sharkcutup »

Check on all layers to make sure there are no stray vectors present.

Would it be possible to post your .crv file? If you cannot due to copyright infringement (models, etc...) then post file without the models in them.

Other than the above noted possibility it is very difficult to diagnose your problem. Without the .crv file members here can only guess as to you problem.

Sharkcutup
V-Carve Pro Tips, Gadget Tips & Videos
YouTube Channel - Sharkcutup CNC
V-Carve Pro 11.554

Char
Posts: 13
Joined: Wed Jun 20, 2018 8:33 pm
Location: Eagle River WI

Re: Random circle twice

Post by Char »

Here is the .crv file.
Attachments
plaque.crv
(10.51 MiB) Downloaded 213 times
Be the kind of woman a man fears, fix things, build things and do it right the first time!

sharkcutup
Posts: 408
Joined: Tue Mar 08, 2016 5:23 pm

Re: Random circle twice

Post by sharkcutup »

Looking over your .crv file and I do not see anything out of the ordinary there.

What post processor are you saving the Toolpaths to?

Sharkcutup
V-Carve Pro Tips, Gadget Tips & Videos
YouTube Channel - Sharkcutup CNC
V-Carve Pro 11.554

sharkcutup
Posts: 408
Joined: Tue Mar 08, 2016 5:23 pm

Re: Random circle twice

Post by sharkcutup »

plaque.png
Smoothed Out Center
plaque1.png
Rustic Center

Interesting Choice

Sharkcutup
V-Carve Pro Tips, Gadget Tips & Videos
YouTube Channel - Sharkcutup CNC
V-Carve Pro 11.554

Post Reply