Search found 5 matches
- Wed Jul 12, 2017 2:24 pm
- Forum: Software. Programming
- Topic: Incomplete file load
- Replies: 0
- Views: 3494
Incomplete file load
Trying to run tap file from flash drive and also from computer. Shark control panel shows complete file on screen but after running virtual setup and reloading tap file, it won't load complete file. Router starts up, makes a couple moves and goes back to Zero. Its obvious when this happens because g...
- Thu May 18, 2017 10:25 pm
- Forum: CNC Shark
- Topic: Tell us where you're from map
- Replies: 617
- Views: 530994
Re: Tell us where you're from map
Another from Granite City, ILL
Butch
Butch
- Wed Jan 25, 2017 11:17 pm
- Forum: CNC Shark
- Topic: Securing wood to the CNC router
- Replies: 18
- Views: 11586
Re: Securing wood to the CNC router
I made a table extension for mine. Took some mdf I had laying around, made a 90 degree and bolted it to the face. Put a couple gussets in for support. Originally put some threaded inserts in for some Rockler hold downs. I have since put in channel aligned with the table slots. Marked the travel pas...
- Mon Aug 22, 2016 9:48 pm
- Forum: Software. Programming
- Topic: Using Piranha tap file on a Shark
- Replies: 3
- Views: 4081
Re: Using Piranha tap file on a Shark
Thanks all. I tried it today, raising cutter above wood and cut air first. Ran 3 different tap files from my flash drive through the shark control panel and all went well
- Fri Aug 19, 2016 9:24 pm
- Forum: Software. Programming
- Topic: Using Piranha tap file on a Shark
- Replies: 3
- Views: 4081
Using Piranha tap file on a Shark
I have a Piranha cnc and access to a couple Shark cnc machines. wondering if my tap files will work on the Shark controller.