Search found 5 matches
- Tue Nov 19, 2019 6:55 pm
- Forum: Everything 4th Axis
- Topic: carving on my turning is mirrored
- Replies: 4
- Views: 7533
Re: carving on my turning is mirrored
Was it difficult to edit the post processor to change this? I don't want to have to jiggle the toilet handle every time I flush if you know what I mean.
- Mon Nov 11, 2019 6:31 pm
- Forum: Everything 4th Axis
- Topic: carving on my turning is mirrored
- Replies: 4
- Views: 7533
carving on my turning is mirrored
I made a candle stand and the letter S is on it. It previews fine but carves backwards. Apparently there is a setting to mirror this but I am not able to open up preference settings for A axis on my computer and the pendant has no setting for this.
- Fri May 11, 2018 5:30 pm
- Forum: Everything 4th Axis
- Topic: Rolling Pin with writing on it
- Replies: 5
- Views: 8919
Re: Rolling Pin with writing on it
Well, good news! I marked the chuck on the 4th axis and selected 360 and it turned almost 1.5 turns. I then did some basic updates to the controller and the LCD and tried it again and it fixed it! I'm glad that was all it was.John
- Sat May 05, 2018 3:11 pm
- Forum: Everything 4th Axis
- Topic: Rolling Pin with writing on it
- Replies: 5
- Views: 8919
Re: Rolling Pin with writing on it
Thanks so much Thom,
I have not tried that yet. That is a great place to start. I have drawn up several others and they are all off but show well in the preview. we are inundated with graduation this weekend but Monday I will see where your advice leads me. I appreciate your input.
John
I have not tried that yet. That is a great place to start. I have drawn up several others and they are all off but show well in the preview. we are inundated with graduation this weekend but Monday I will see where your advice leads me. I appreciate your input.
John
- Thu May 03, 2018 12:58 am
- Forum: Everything 4th Axis
- Topic: Rolling Pin with writing on it
- Replies: 5
- Views: 8919
Rolling Pin with writing on it
I drew up a rolling pin in aspire 2.25 in. in diameter and 12 inches long and put four lines of writing on it to v carve. Unwrapped the circumference was a little over 7 inches. I left roughly 1/2 inch top and bottom (which would be the seam) and when I carved it the first time it came out to where ...