Search found 3 matches
- Thu Apr 13, 2023 10:44 am
- Forum: Software. Programming
- Topic: Depth of cut
- Replies: 2
- Views: 1443
Re: Depth of cut
Changing the machine to 4004 was not the answer - it actually was worse. I bumped the depth of cut to .80, and it did cut through in places. While not optimal, and prone to not producing the results I expect, is there anything else I should check? With the cut not parallel to the board, I will check...
- Wed Apr 12, 2023 2:42 pm
- Forum: Software. Programming
- Topic: Depth of cut
- Replies: 2
- Views: 1443
Re: Depth of cut
For the "file not referenced to center" issue, I found a Virtual Zero option under Apps on the pendant, so I set that to 'No' and the warning message went away
On another post I found that for the H520, the machine should be set to 4004. I'll try that and see if it fixes my issue
On another post I found that for the H520, the machine should be set to 4004. I'll try that and see if it fixes my issue
- Wed Apr 12, 2023 10:53 am
- Forum: Software. Programming
- Topic: Depth of cut
- Replies: 2
- Views: 1443
Depth of cut
I am doing my first project, a simple Ohm symbol using MDF. I have the depth of cut set to .73, which is the material thickness. After bit changes I move the bit to contact the material surface at the X:Y 0:0 location and reset the Z to zero. I ensured the Z travel will allow the bit to go beyond .7...