Search found 93 matches
Here's what I never understand: Why do guys like you, who figure out how to do things like this, NEVER actually include WHAT you did? Nor even where you found the solution. You're a prime culprit is this regard Rando. You post these long written solutions that actually don't most of the time give e...
- Mon Jan 11, 2021 7:23 pm
- Forum: CNC Shark
- Topic: 15 Watt Diode Laser (Not Next Wave)
- Replies: 5
- Views: 2437
Me too Sharkcutup! Sorry, but I'll pass Rando on your Big Mouth project.
- Tue Nov 24, 2020 6:38 pm
- Forum: Setting up the Shark
- Topic: Custom touch plate
- Replies: 9
- Views: 6850
The only thing I've encountered is problems if I start running gcode when I'm not at (0,0,0). It's probably because of relative moves in g-code, rather than absolute. That's perhaps the reason Kayvon. My post command is for Absolute Mode and it pretty much dead on. I know when I was a beta tester f...
Your post implies I would need to look at getting fan in the controller box? Bill, You said you've run the job a few times before without issue. I seriously doubt heat is an issue - I'd suspect perhaps a brownout or something else gremlin like. My thoughts would be to simply monitor it going forwar...
I'm familiar with the options for powering and fan choices - just thought Rando you'd have a picture to share! I think I'll pass - can't see how it would help much and likely would just suck in sawdust and the like to for sure than over heat components. Mine has never got hot enough that I couldn't ...