CNC Shark Forum

Fine, you lame-ass lazy people. Rando, it's time to step back and take a deep breath. I agree with your complaint about not sharing the solution the OP found. The more we share, the more we help each other. To that end, I went and looked up how to find the latest version of the document you linked ...

There's no way to pick up where you left off. If you can reset the gantry to the exact starting position, you can rerun the entire job.

Can't answer all the questions in your rant, but there's a document entitled Guide to Editing a Vectric Post Processor that came with my VCarve installation. It's right there in the help menu: Help > Post Processor Editing Guide I've had good success following its instructions to make custom modific...

How deep are your passes? Quarter-inch bit?

I don't have any spindle experience, but are you using distilled water? Tap water contains minerals that can cause calcium and other buildups in some instances.

Those puzzle boxes are beautiful. Nicely done!

Some sort of HD model, but I don't know which. If you figure out the possible cutting area, that'll help you narrow it down.

$2300 is a good deal. They run around $4000 new.

When it was new, that package sold for $5k. It's now an older model that's no longer stocked.

It's worth what you can get for it, of course. I would spitball $3k as a starting point.

Does it do this on all axes? Does it do this when you jog a fixed distance with the pendant?

Please provide some detail about your setup. Which machine are you using? Which software? Has is worked in the past? What changed?