CNC Shark Forum

Got it now. Some how my reg key for 2.0 controller software got deleted. Actually was able to find email with info needed and re registered the 2.0 software and it generated a key and automatically entered it. Now I finally have the ruun virtual setup box appearing under the g code box. Had a feelin...

For some reason my virtual is not working, does not even show a selection box for it on startup or after I load g code. Checked preferences and the selection box was unchecked in the virtual pref. So I checked it and saved changes with ok. Still does not show up and when i checked the pref virtual t...

Can't find it in shopbot and the vectric is for aspire, I only have v-carve and it wont open.

Looking for plans for library chair (ladder chair, step chair) that are cnc oriented.
Any ideas? Thought I saw something decent here but a search turns up nothing.

I have used the virt z a few times now and found it works wonderful 75% of the time. Some models actually distort a bit (25%). When not using virt z but using same control panel the same tool path works fine. I am starting to learn what 3d models won't do as well with the virtual. I love the concept...

Black Diamond with dewalt 618. I wrapped a single layer of duct tape around the aluminum router
body and have not had a single issue now in 6 months. Cheap and fast and still working.

Thanks for the reply. Used the spray and squeak stopped. Now to see how long before it starts again.

Is there any certain type? Spray or tube applicator. I have the pure silicone spray lube.

When the cutter is going down and close to table is makes a sound like a dry hinge.
Is there something that needs lubrication like the screw? Black Diamond. Otherwise
running good.

Purchased the set of 4 carving bits from Precise Bits. Should I load these as diff size ball
nose bits? Can't really find anywhere else to load these in the tool data base, any suggestions?
Thanks, finally starting to understand this new world.