Page 1 of 1
Aspire trial version limitations
Posted: Sat Jun 29, 2013 4:52 pm
by PQTN
Hello,
I downloaded Aspire trial version to test it. I watched a few tutorials. I began a small project just to see if I can easily use that software. I created 3 toolpaths and wanted to save them into files... but Aspire trial doesn't allow those saves. I'm really desappointed because I would like to carve that small project.
Is there someone who would like to take 5 minutes to save those 3 files for me? If yes, send me a PM to give me your e-mail address and I'll send the crv3d file by e-mail.
Thank you for your time.
PQTN
Re: Aspire trial version limitations
Posted: Sun Jun 30, 2013 12:56 am
by PQTN
Hello again,
I sent my crv3d file to a member of this forum. He couldn't open the file with his Aspire. It seems that file created with trial Aspire (or trial VCarve) cannot be open on another computer than the one on which it was created.
It seems that I will keep that file until I pick up enough empty cans and bottles to pay me the upgrade to Aspire
At first sight, Vectric worked hard to protect their software rights and to sale their softwares...
Re: Aspire trial version limitations
Posted: Wed Jul 26, 2023 2:03 am
by Aliyaaii
PQTN wrote: ↑Sat Jun 29, 2013 4:52 pm
Hello,
I downloaded Aspire trial version to test it. I watched a few tutorials. I began a small project just to see if I can easily use that software. I created 3 toolpaths and wanted to save them into files... but Aspire trial doesn't allow those saves. I'm really desappointed because I would like to carve that small project.
Is there someone who would like to take 5 minutes to save those 3 files for me? If yes, send me a PM to give me your e-mail address and I'll send the crv3d file by e-mail.
Thank you for your time.
PQTN
Hi guys
I understand your disappointment with the limitations of the Aspire trial version. It can be frustrating when you put time and effort into a project only to find out you can't save it.
Re: Aspire trial version limitations
Posted: Wed Jul 26, 2023 12:19 pm
by sharkcutup
If I am not mistaken there are several tutorial files that can be accomplished and saved to carve on CNC Machine! You can even Modify them a bit using Aspire!
You
can save any project you create in
Aspire. You are just
NOT able to
save your Toolpaths for carving due to the fact it is a
Trial Software Version. All Projects you have created can be used once the Software is Licensed to Full Capabilities by Purchasing it from Vectric.
Only Vectric's
Tutorial Files can be
used Fully Within the
Trail Software Versions.
Hope this Makes Sense!!!
Sharkcutup