Virtual Setup - Runs past top

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
tradewinds
Posts: 31
Joined: Wed Dec 16, 2015 6:41 pm
Location: St. Louis, Missouri

Virtual Setup - Runs past top

Post by tradewinds »

When running virtual set-up on a simple six circle cut, the software drives the router assembly past the highest allowable point and I must use E-Stop to abort the program.
The file runs fine, if I just detect the touch plate and bypass virtual set-up.

I bought the shark CNC in 2016 and have confirmed that I am running the most current software.

I have also attached the file.

I went back to the last file I used successfully with Virtual set-up and it now also runs the router assembly past the highest allowable point and I must use E-Stop to abort the program.

Any help will be greatly appreciated.

Mike
Attachments
edge profile.tap
(9.26 KiB) Downloaded 278 times

nicksilva
Posts: 16
Joined: Sun Jul 07, 2019 2:22 pm

Re: Virtual Setup - Runs past top

Post by nicksilva »

I don't know why it works when you bypass the virtual setup since
The gcode says your thickness is .25" but it plunges -.27 in several places.
that should cut too deep regardless of how you set it up.

Post Reply